Brim support does not generate if Build Plate Adhesion is not also set to brim.

[gilaramirez]

Cura Version

5.4.0-Beta 1

Operating System

Windows 10

Printer

Snapmaker A350

Reproduction steps

1, Enable support brim under supports
2. Select no brim or skirt under build plate adhesion

Actual results

No brim is created around supports. Support/Brim width or line count has no effect on actual line count/width of support brim.

Expected results

A brim should have been created around just the supports. The support/brim width would override the build plate adhesion/brim type. -brim width, or -line count.

Add your .zip and screenshots here ⬇️

CFFFP_Body-White-Portal-Gun-3-1.zip

[Asterchades]

This is a known issue and should be fixed with the next Cura release. Until then you will need to use either a Brim or Skirt in order to get the Support Brim to generate properly.

Duplicate of #14983.