Skip to content

Latest commit

 

History

History
37 lines (37 loc) · 1.54 KB

STM32H7ToDo.md

File metadata and controls

37 lines (37 loc) · 1.54 KB
Raw
  • Board pin definitions
  • Extra SPI definitions SPI5 & 6
  • Allow SPI to work with/without DMA to unaligned/aligned addresses
  • SPI DMA - Fix to work when no recv buffer & DMA
  • ADC calibration constants seem to be using 16bit samples but we expect 12bit
  • SDIO card interface
  • DMA memory buffers (re-enable dcache currently disabled)
  • TMC2209 interface
  • Test TMC5160 interface
  • Check neopixel timing (consider using dma)
  • Sort out STM32F4 and STM32H7 defines consider having base STM32 define
  • WiFi interface
  • Check clock timing
  • Enable 16bit ADC samples (currently 12 bit with oversampling to 14)
  • Use processor d-ram for stacks etc.
  • Check UART code
  • Consider using FIFOs for UARTS
  • Common STM32 Core?
  • Crash dump flash interface
  • CAN support
  • Investigate SD Card SPI mode high speed switching
  • Test SBC mode
  • Build H7 IAP for SBC mode
  • Sort out a H7 bootloader for Fly boards
  • Check H7 timer allocation
  • use QSPI for neoplixels or use DMA
  • Allow use of shared timers per pin (find best match)
  • Update hardware usage for H7
  • Allow DMA with SPI1, SPI5, SPI6
  • Replace ST USB library
  • Allow use of embeded config
  • Set initial pin state from board.txt
  • Add support for humidity sensors
  • Allow setting of neopixel pins
  • Fix F4 PWM pin timer allocation for pin PD_13 to match H7
  • Allow default thermistor resistor value to be changed on a per board basis (for PT1000 etc.)
  • Consider making default thermistor value part of the per board configuration