Name | Quantity | Note |
---|---|---|
PCB | 1 | |
Mount Plate | 1 | FR4(PCB plate) |
Acrylic Bottom Plate | 1 | |
Acrylic Pro Micro Cover | 1 | |
M2 spacer 8mm | 2 | use with Acrylic Pro Micro Cover |
M2 spacer 7mm | 8 | use with Acrylic Bottom Plate |
Plastic spacer 2mm | 8 | use with Acrylic Bottom Plate |
M2 Screw 4mm | 18 | |
M2 Black Screw 4mm | 2 | Top use with Acrylic Pro Micro Cover |
Rubber Feet | 8 | |
1N4148 diode | 48 | |
TRRS Jack | 1 | not use |
Reset Switch | 1 |
Name | Quantity | Note |
---|---|---|
MicroUSB cable | 1 | |
Key Switches | 47~48 | Compatible for MX |
Key Caps | 47~48 | compatible for MX stem, Better than ANSI104 keysets |
Pro Micro | 1 | |
Pin 12P | 2 | For use with Pro micro |
Kailh MX Socket | 47〜48 | Kailh socket |
Stabilizer | 1~2 | PlateMount |
LED strip(WS2812B x6) | 2 | Underglow |
Make example for this keyboard (after setting up your build environment):
make treadstone48:default
See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.
Steps.
- Lead Forming
- Insert in the through hole (Be careful of the direction of the diode)
- Soldering
The parts of the picture can be installed according to your preference.
A first, Combine the PCB and the mounting plate.
And then Insert the socket into the pin of the switch protruding from the PCB. (be careful with the orientation)
Solder the terminal and PCB of both ends of the socket.
Be careful with the orientation.
Be careful with the orientation.
Use an 8 mm spacer, 2 4 mm screws and 2 4 mm black screws. Attach the cover to the PCB.
Use 8 spacers of 7 mm, 8 spacers of plastic and 16 screws of 4 mm. Remove the bottom plate protective paper and attach the PCB.