You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
apologies for the noob question... I've set up my WiCAN which seems to be working fine and I can see data both with Car Scanner but also published correctly on my MQTT broker. I was planning to use to monitor my fuel tank consumption (it's a RV so apart the engine I have a generator and the heating system serviced by the same tank) while the vehicle is parked. However data is updated only with the vehicle turned on. Is this correct? any other way to get the level updated when the engine and dash is off? battery drain is not an issue as I have a dedicated charger for it.
Thanks for your help
The text was updated successfully, but these errors were encountered:
Hi
apologies for the noob question... I've set up my WiCAN which seems to be working fine and I can see data both with Car Scanner but also published correctly on my MQTT broker. I was planning to use to monitor my fuel tank consumption (it's a RV so apart the engine I have a generator and the heating system serviced by the same tank) while the vehicle is parked. However data is updated only with the vehicle turned on. Is this correct? any other way to get the level updated when the engine and dash is off? battery drain is not an issue as I have a dedicated charger for it.
Thanks for your help
The text was updated successfully, but these errors were encountered: