You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
3D printer brand / version + firmware version (if known)
Prusa MK3S + MMU2S
Behavior
When I change the type of printer, my purge volumes are reset.
I have one MK3S and one MK3S + MMU2S.
When change printer profile from MK3S to MK3S + MMU2s and vice versa, values are reset (unloading 70, loading 70 for the 5 filaments)
So, can you save these values in the printer profile such as is done with color ?
And, when I restart PrusaSlicer, I must set these values yet. It's so painful to change these values all the time.
Many thanks for your job.
I hope that you will include this proposal in the new version.
Best regards,
Cyril
The text was updated successfully, but these errors were encountered:
This issue and #3581#2990#1282#1693 all seem to be duplicates of one another, or anyway dupes of the underlying idea, that purge volumes aren't saved in a user-friendly way.
In my opinion, purge volumes need to be saved and loaded in such a way that the user can build up a full table of relationships over time, to theoretically eventually cover all of the filaments he or she uses.
Personally, I favor storing the table in the printer profile; the user can then just adjust the relationships every so often i.e. when a new filament needs to be added to the table, and then just re-save the printer profile. Storing it there makes the most sense, since different hardware (I.e. one hotend vs. another, or direct-feed vs. bowden-fed) will affect purging behavior.
Version
Version 2.2.0-rc+win64
Operating system type + version
Windows 7 64bits
3D printer brand / version + firmware version (if known)
Prusa MK3S + MMU2S
Behavior
When I change the type of printer, my purge volumes are reset.
I have one MK3S and one MK3S + MMU2S.
When change printer profile from MK3S to MK3S + MMU2s and vice versa, values are reset (unloading 70, loading 70 for the 5 filaments)
So, can you save these values in the printer profile such as is done with color ?
And, when I restart PrusaSlicer, I must set these values yet. It's so painful to change these values all the time.
Many thanks for your job.
I hope that you will include this proposal in the new version.
Best regards,
Cyril
The text was updated successfully, but these errors were encountered: