Digilent Atlys

Jump to bottom Edit New page

Tim Ansell edited this page Sep 1, 2018 · 8 revisions

Configuring the Atlys

Before loading the gateware you need to set the jumpers correctly and connect the cables correctly.

FIXME: Put something here about the Atlys.

Jumpers Configuration

As the HDMI2USB firmware manipulates the EDID information the following jumpers must be removed;

JP2/SDA (which connects the EDID lines from J1/HDMI IN to JA/HDMI OUT).
JP6 and JP7 (which connects the EDID lines from J3/HDMI IN to J2/HDMI OUT).

Cables

Plug board in using PROG port & switch on. If using a VM, ensure the device is passed through.
The other UART port is for the controlling the firmware. Recommend plugging this in too so you can use/test the device.