Skip to content

Latest commit

 

History

History
26 lines (18 loc) · 1.37 KB

readme.md

File metadata and controls

26 lines (18 loc) · 1.37 KB

Arduino-Shield to flash EEPROMs

This is an Arduino shield that can be used to read or flash EEPROMs. I've successfully flashed 28C16 and 28C64.

Hardware

The schematic you can find here. It has been created with KiCad 5.1.12.

The 74'595 shift registers are used to set the address lines A0-A12, /CS, /OE and /WE. The address lines A13 and A14 for 28C128 or 28C256 are only available through jumpers, so only up to 8kB could be flashed in one row.

The EEPROMs data pins are connected via resistors to the arduino pins D0-D7 to prevent problems if the EEPROM and the Arduino accessing these pins as output. For those arduino boards that use pins D0 and D1 for serial communication, you can use AD0 and AD1 instead. In that case omit the resistors to D0 and D1, install those to AD0 and AD1, and change the constants PIN_D0 and PIN_D1 at the beginning of the Eprommer595.ino.

Note, you need to solder the pin headers onto the bottom side (in contrast to the below 3D view).

3D-View

Software

For simplicity the data to flash should be provided as array content (see data_jute6k_video.h). Any output is provided over serial communication (9600 baud).

Todo

  • reserve more space around EEPROM to be able to mount a ZIF socket