You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Is there any way to disable routing so this shows up as an end point?
I’ll be using it for a special project powered by a (large) battery. But I don’t want other devices to connect to it because it will lose power every time I swap the battery or it runs down, and I fear that would cause network instability.
Thank you!
The text was updated successfully, but these errors were encountered:
There are two options - first use special end device firmware, second use special PSM mode firmware. For both of them, you'll require CC Debuger to flash new firmware.
Is there any way to disable routing so this shows up as an end point?
I’ll be using it for a special project powered by a (large) battery. But I don’t want other devices to connect to it because it will lose power every time I swap the battery or it runs down, and I fear that would cause network instability.
Thank you!
The text was updated successfully, but these errors were encountered: