[CURA-7979] Add 'Outer Wall Lock Factor' setting. #9245
Closed
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
Most of this work is in the Engine, see: Ultimaker/CuraEngine#1405
Arachne produced artifacts in straight outer walls if the inner walls had curves in them (or appeared and dissapeared behind them). 'Hard' fixing that would reduce the flexibility of Arachne, so a setting is introduced how much the outer walls should be locked into place (as much as possible at 100%, not at all at 0%).