'cisco_xe' device_type not mapping through to ntc-templates properly #2112
-
Hello, |
Beta Was this translation helpful? Give feedback.
Replies: 6 comments 2 replies
-
Are you using ntc-templates? Does the given command you are trying to parse exist in the index file of ntc-templates? Assuming you are using ntc-templates, this is probably more of a question that should be directed there. Regards, Kirk |
Beta Was this translation helpful? Give feedback.
-
I would Does that fix the issue? |
Beta Was this translation helpful? Give feedback.
-
Okay, next most likely problem is that the existing TextFSM template doesn't properly handle your particular output. That would be an ntc-template issue: |
Beta Was this translation helpful? Give feedback.
-
I received some assistance over at github.com/networktocode/ntc-templates. I was asked to run the following...
That produced the desired output. Then I was referred back here. Any thoughts on what I'm missing / doing wrong? |
Beta Was this translation helpful? Give feedback.
-
I think I figured out my problem. I had set |
Beta Was this translation helpful? Give feedback.
-
No, that is something I should fix on my side or at least warn you about. Let me flag it as a bug to see if we can improve that behavior. |
Beta Was this translation helpful? Give feedback.
I received some assistance over at github.com/networktocode/ntc-templates. I was asked to run the following...
That produced the desired output. Then I was referred back here. Any thoughts on what I'm missing / doing wrong?