Resetting circle diameter once animation ends

[ejwm]

2vid_loom_repeat.zip
Hi,
I'm fairly new to Bonsai and am looking for a little help.
I am trying to create a looming stimulus. The stimulus starts with 10s with a blank screen, then holds on the circle for 10s, then I have animated a circle from BonVision to change from diameter 0.1 to 2.5 over a period of time. However, this means that when I run the file again the circle starts at diameter 2.5 rather than resetting to 0.1. Is there any way to reset?
Thanks,
Eira

[bruno-f-cruz]

Remove the SubscribeWhen connected to RangeAnimation. Alternatively, you can also just send a single Float value at the start of the sequence by using the Merge operation after RangeAnimation.

Hope it helps!

[ejwm]

Thanks for answering! Sending the float and merging did exactly what I needed